These are the large interactive displays in the BBLC Lecture Hall, BBLC Conference room, and Library Seminar Room.
1. Turn it on. Power button is in the Lower right front, it should be flashing Red/Blue. If this button is unresponsive, there is a primary power switch on the back right. Toggle that to completely reset the display.
2. Change the input to the AppleTV. Pull out the control drawer at the bottom center of the display. Press the gear icon to bring up the settings. Tap on the interactive panel where it says Input and then choose the HDMI input of the AppleTV (it'll likely have a yellow dot under it).
3. Make sure the AppleTV is ON by pressing the power or TV/Home button on the remote. The remotes are Bluetooth and do NOT need to be pointed at the device to work. (the older/smaller appletv remotes DO need to be pointed at the device to work.)
4. Airplay as you usually would in any classroom. If the AppleTV doesn't show in the list, try restarting the AppleTV. Using the AppleTV remote, click the TV/Home button, then navigate to Settings > general > Restart.
Important: Do not select Reset! This will put the device out of commission for at
least 15min and change the name to the serial number.